McIntosh MC205 Manual do Proprietário

McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.comMC205Power AmplierOwner’

10Bare wire cable ends:Carefully remove sufficient insulation from the cable ends, refer to figures 1, 2 & 3. If the cable is stranded, carefully

11ance of the Front Loudspeakers. If the Loud-speaker’s impedance is 6 ohms, select the 4 ohms setting. Refer to “General Information” Note 4 on page

12Front Panel Displays and ControlsStandby Power On IndicatorMeter indicates the Power Output of the amplifier for Channels 1, 3 and 5LED indicates wh

13PowerWith the POWER Switch set to the OFF/REMOTE Position, the MC205 will turn On or Off when an A/V Control Center turns On or Off. For manual oper

14A continuous average power output rating of 200 watts and an output current of greater than 25 amperes per channel, makes this one of the most advan

15Therefore, it is important that they plug directly into the wall outlet.Also, most owners desire one power switch for the whole audio system. The MC

16

17Photos

18Power OutputMinimum sine wave continuous average power output per channel, all channels operating is:200 watts into a 4 ohm or 8 ohm loadOutput Load

19Packing InstructionsPacking InstructionsIn the event it is necessary to repack the equipment for shipment, the equipment must be packed exactly as s

2The lightning ash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” w

The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice.Pr

3Thank YouPlease Take A MomentTechnical AssistanceIf at any time you have questions about your McIntosh product, contact your McIntosh Dealer who is f

4XLR ConnectorsBelow is the Pin configuration for the XLR Balanced Input Connectors on the MC205. Refer to the diagram for connection: PIN 1: Shield/

5DimensionsThe following dimensions can assist in determining the best location for your MC205.DimensionsFront View of the MC205Rear View of the MC205

6InstallationInstallationThe MC205 can be placed upright on a table or shelf, standing on its four feet. It also can be custom installed in a piece of

7Rear Panel Connections and SwitchConnect the MC205 power cord to a live AC outlet. Refer to the rear panel to determine the correct voltageMain Fuse,

85. Referring to figure 5, connect the Loudspeaker hookup cables with banana plugs into the hole at the end of the MC205 Negative and Positive Output

99. Place the IMPEDANCE Switch to the position (4 ohm or 8 ohm) to match the impedance of the connected Loudspeakers. In the event that some of the Lo