McIntosh C45 Manual do Proprietário descarregar pdf (Página 20)

Setup, con’t

Remote Control Selection

The C45 will respond to two different sets of the Remote

Control Codes. The Remote Control included with the C45

utilizes the NORMal McIntosh Control Codes. The Second

Set of Control Codes the C45 will respond to is referred to

as the ALTernate Codes. The ALTernate Codes are for when

the C45 is used together with an other McIntosh Audio or

Audio/Video Control Center or Preamplifier in the same

system. This will prevent the Remote Control from affecting

the operation of both units at the same time.

Note: If the ALT Remote Control Code is selected, the C45

will not respond using the supplied McIntosh Remote

Control. See your McIntosh Dealer for additional

information.

1. Press the SETUP Push-button to access the Setup

Mode.

2. Press the TONE BYPASS (Menu) Push-button until

“REMOTE NORM” appears on the Front Panel Alpha-

numeric Display. Refer to figure 29.

3. Press the TRIM LEVEL UP or Down Push-but-

ton until the display indicates “REMOTE ALT”. Refer

to figure 30.

4. Press the SETUP Push-button to exit the Setup Mode.

Figure 29

Figure 30

Figure 28

3. Press the TRIM LEVEL UP or Down Push-button

until the display indicates “AUTOTONE ON”. Refer

to figure 28.

4. Press the SETUP Push-button to exit the Setup Mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Sem comentários

McIntosh C45 Manual do Proprietário Página 20