McIntosh C45 Manual do Proprietário descarregar pdf (Página 23)

How to Operate the C45, con’t

Setup

Pressing the SETUP Push-button activates the Setup Mode

of the C45 and allows customizing various operating func-

tions. Refer to the SETUP Section of this Owner’s Manual

starting on page 15. Refer to figure 40.

Reset of Microprocessors

In the event that the controls of the C45 stop functioning,

push the POWER switch OFF and wait about two minutes.

Then push the POWER switch ON followed by pushing the

STANDBY/ON Push-button. This will reset the C45 micro-

processors and the Audio Control Center will be returned to

normal operation.

Note: The above condition is usually caused by either

interruptions in AC power and/or major changes that

may occur in AC power line voltage.

Default Settings

To restore the C45 to Factory Default Settings perform the

following. Press and hold in the 6CH MODE Push-button

together with the MUTE Push-button. Approximately 5 sec-

onds after holding in the Front Panel Push-buttons, the

Front Panel Alphanumeric Display will indicate “MASTER

RESET”. Refer to figure 38.

Release both Push-buttons and the Front Panel Alphanu-

meric Display will now indicate “-- CLEARED - -” and the

C45 will switch Off. Refer to figure 39.

Press the STANDBY/ON Push-button on the C45 and pro-

ceed to the Setup on page 15 to re-enter and custom settings

that have been previously made.

Figure 38

Figure 39

Figure 41

Figure 40

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Sem comentários

McIntosh C45 Manual do Proprietário Página 23