McIntosh MC-2125 Manual do Utilizador

THE MclNTOSH MC 2125 SOLID STATE STEREO POWER AMPLIFIERReading Time: 31 MinutesPrice $1.25

Rear Panel InformationLEFT and RIGHT OUTPUTFor stereo operation, output impedances of 2, 4, 8 and16 ohms have been provided on a secure, screw type ba

Performance Limits and RatingsPERFORMANCE GUARANTEEPerformance Limits are the maximum deviation from per-fection permitted for a Mclntosh instrument.

12

13

Technical DescriptionINPUT AMPLIFIERSeparate input amplifiers are used for the right andleft channels. Each input amplifier is a two transistor feed-b

applied differentially to a high gain operational amplifierwhere it is amplified about 100 times. The amplifiedcontrol voltage is detected by a full w

16

MclNTOSH LABORATORY INC.2 CHAMBERS ST., BINGHAMTON, N. Y. 13903607-723-3512Design subject to change without notice.Printed in U.S.A.038-885

Your MC 2125 Stereo Power Amplifierwill give you many years of pleasantand satisfactory performance. If youhave any questions, please contact:CUSTOMER

INPUTSTEREO OR TWIN AMPLIFIER OPERATIONUse shielded cables to connect the signal from the pre-amplifier or signal source to the power amplifier. To mi

If a load impedance is used that is lower than the outputimpedance tap, then reduced power and possible distortionwill result If a load impedance is u

StereophonicConnectionsMUST BE IN STEREOPOSITION FOR STEREOPROGRAMSLEFTSPEAKER6STEREOMODESWITCHMONORIGHTSPEAKERPROGRAM SOURCE

MonophonicConnectionsCONNECT FOR MONO USEONLY WHEN THE MODESWITCH IS IN MONOPOSITIONSTEREOMODESWITCHMONOPROGRAM SOURCE7

Front Panel InformationMETERSOutput power monitor meters indicate the output powerof each channel. Each meter has two primary scales:WATTS and DECIBEL

strip on the rear panel. The meter is calibrated for 300watts at the right hand end of the meter scale. While theMC 2125 cannot reach this power level